MITCalc - Buckling Calculation - Calculation of the slender strut (column) buckling
The program is designed to calculate the optimum cross-section and perform strength check of slender struts
strained for buckling. The program includes:
- Selection of six basic types of buckling.
- Calculation of area characteristics of 20 types of cross-sections.
- Design of optimum profile accommodating the set load.
- Strength check of the strut.
- Calculation and graphical representation of permitted stress dependent on slenderness rate.
- A table of materials and a table of area characteristics of W, S, C and L profiles according to ANSI/AISC and I, U,
L and T profiles according to DIN/ISO.
The calculation is based on data, procedures, algorithms (Johnson, Tetmajer, Euler, Secant) and data from
specialized literature and AISC, ISO, DIN and BS standards.
List of standards (DIN 1025, 1026, 1028, 1029, 1024, AISC W, S, C, L, LU ... ) This module is a part of MITCalc -
Mechanical and Technical Calculation Package for gear, belt and chain drives, springs, beam, shaft, bolt
connection, shaft connections, tolerances and many others
Limitations: 30 Days Trial

MITCalc - Buckling Calculation 1.17 is 100% clean
This download (MITCalcBuckling01.exe) was tested thoroughly and was found 100% clean. Click "Report Spyware" link on the top if you found this software contains any form of malware, including but not limited to: spyware, viruses, trojans and backdoors.

 

1. MITCalc - Worm Gear Calculation 1.14 - Geometric design and strength check of worm gear
2. MITCalc - Rolling Bearings Calculation I 1.16 - Selection, calculation and check of rolling bearings
3. MITCalc - Rolling Bearings Calculation II 1.16 - Selection, calculation and check of rolling bearings (inch)
4. MITCalc 1.60 - Mechanical, Industrial and Technical Calculations for many CAD systems
5. MITCalc3D for SolidWorks 1.60 - Mechanical, Industrial and Technical Calculations for SolidWorks
6. MITCalc - V-Belts Calculation 1.18 - Geometric design and strength check of V-belt transmission
7. MITCalc - Internal Spur Gear Calculation 1.16 - Geometric design and strength check of internal spur gear (straight and helical)
8. MITCalc - Tolerances 1.17 - Tolerances, deviations and fits of machine parts
9. MITCalc - Force shaft connection 1.17 - Designs and strength checks of force couplings of shafts with hubs
10. MITCalc - Shaft connection 1.18 - Designs and strength checks of shaped connections of shafts with hubs